Filter
Top Products
56
Heat & Glo • TRUE-36, TRUE-42, TRUE-50 • 2282-900 Rev. D • 8/12
Log #4 (2280-704 for TRUE-36; 2281-704 for TRUE-42): See Figure 7. Place Log #4 between the left and center grate
tines. Notches on log will rest on tines. Log should be positioned as far forward as possible. See Figure 8. Log #4 will
lean against Log #2.
Log #3 (2281-703): Locate log placement notches for Log #3. See Figure 5. Place Log #3 onto notches so that the bottom
of the log rests in the notch on log #2 and the top rests in the left hand side of the notch on Log #1. The top of the burned
area on Log #3 will be close to Log #1 when properly positioned. See Figure 6.
Figure 7.
RIGHT
RIGHT
HAND
HAND
NOTCH
NOTCH
4
4
5
5
FLAT AREA
FLAT AREA
FOR LOG #5
FOR LOG #5
Figure 8.
4
4
Figure 6.
LOG RESTING IN NOTCH
LOG RESTING IN NOTCH
TOP OF BURNED
TOP OF BURNED
AREA NEAR LOG #1
AREA NEAR LOG #1
2
2
1
1
3
3
LEFT
LEFT
HAND
HAND
NOTCH
NOTCH
LOG CONTACTS
LOG CONTACTS
LEFT GRATE TINE
LEFT GRATE TINE
LOG CONTACTS
LOG CONTACTS
CENTER GRATE
CENTER GRATE
TINE
TINE
NOTCH
NOTCH
LOG #5 APPEARANCE
LOG #5 APPEARANCE
VARIES SLIGHTLY
VARIES SLIGHTLY
BETWEEN MODELS
BETWEEN MODELS
Figure 9. Log #5 - TRUE-36.
LOG CONTACTS LEFT
LOG CONTACTS LEFT
SIDE REFRACTORY
SIDE REFRACTORY
5
5
4
4
LOG POSITIONING
LOG POSITIONING
TAB FOR LOG #5
TAB FOR LOG #5
LOG CONTACTS LOG
LOG CONTACTS LOG
POSITIONING TAB
POSITIONING TAB
LOG #4 CONTACTS
LOG #4 CONTACTS
LOG #2
LOG #2
Figure 10. Log #5 - TRUE-42
5
5
4
4
REAR GRATE TINE
REAR GRATE TINE
FRONT GRATE TINE
FRONT GRATE TINE
Log #5 (2280-705 FOR TRUE-36, 2281-705 FOR TRUE-
42): Locate fl at area on Log #4 that will be used to position
Log #5. See Figure 8. Place Log #5 into appliance as shown
in Figure 9 or Figure 10. Left end of log should rest against
left side refractory just in front of air inlet on rear, lower left
of appliance.
Log #5 (TRUE-36): Log #5 will sit about halfway between
front and rear grate tines, partially over pilot assembly. Log
#5 will contact log positioning tab as shown in Figure 9. Right
side of Log #5 will rest in notch on Log #4. See Figure 9.
Log #5 (TRUE-42): Log #5 will rest against the rear grate
tine as shown in Figure 10. Right side of Log #5 will rest in
notch on Log #4. See Figure 10.
LOG CONTACTS LEFT
LOG CONTACTS LEFT
SIDE REFRACTORY
SIDE REFRACTORY