Filter
Top Products
Hearth & Home Technologies - Colville
1445 North Highway, Colville, WA 99114-2124
VILLAGE COLLECTION ELECTRIC FIREPLACE
09/03
14
4030-240 Rev F
2. Hand Held Remote Control Transmitter - RCE-QUAD (Optional)
a. The RCE-QUAD is an optional accessory listed with the QV32E and QV32EV.
b. The transmitter is a radio frequency remote control. The frequency can be found on the back side of the transmitter. The range
of the transmitter is approximately 20 from appliance.
c. When the remote LED light is RED, the appliance has been turned on/off by the remote transmitter. The manual controls
located on the dashboard will override any other external controls (remote control/wall switch) used to operate the appliance.
d. Hand Held Remote Transmitter/Appliance Initialization
1) The transmitter operates on a 12V battery (included) made specifically for remote controls and electronic lighters. Install
the 12V battery supplied with the appliance into the battery compartment of the hand held remote transmitter. It is
recommended that alkaline batteries always be used for longer battery life and maximum operational performance. If the
signal light does not illuminate (when it normally would), check the position of the transmitters battery.
2) Initialization only has to be done once.
WARNING!
Changes or modifications to this device not expressly approved by the party responsible for compliance
could void the users authority to operate the equipment.
3) Turn the main power switch on and then turn the flame switch on.
4) Locate the LEARN button on the dashboard. The LEARN button is located behind the lower grille/panel. To push the
button, use a blunt object (such as a pencil).
5) Push the button in and release. The remote LED light should blink green. The remote LED light is located above the main
power switch.
6) Push and hold either the on or off button on the hand held remote transmitter. The remote LED light should begin to blink
rapidly.
7) Release the button on the hand held remote transmitter and the remote LED light should stop blinking green and go out.
This indicates that the transmitter and appliance are initialized. If the remote LED light turns red, the hand held remote
transmitter is active.
8) The hand held remote transmitter is ready to be used.
Note: If you lose power during operation or by turning the main power switch to OFF, the appliance will
need to be reset. To reset the appliance, make sure that you have power to the appliance and the main
power switch is in the ON position. Turn the flame switch off and on to reset the appliance.