Hearth and Home Technologies A36C Indoor Fireplace User Manual


 
6
1
1
Listing and Code Approvals
NOTICE: This fireplace is tested and approved as a
decorative replace. It should not be factored as a primary
heat source in residential heating calculations.
WARNING! Risk of Fire! Hearth & Home Technologies
disclaims any responsibility for, and the warranty and
agency listing will be voided by the following actions.
DO NOT:
install or operate damaged replace
modify replace
install other than as instructed by Hearth & Home
Technologies
operate the replace without fully assembling all
components
over re
install an unvented gas log set
install any component not approved by Hearth & Home
Technologies
install parts or components not Listed or approved
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. For
assistance or additional information, consult a quali ed
installer, service agency or your dealer.
B. Non-Combustible Materials
Materials which will not ignite and burn, composed of
any combination of the following:
- Steel - Iron
- Brick - Tile
- Concrete - Slate
- Glass - Plasters
Materials reported as passing ASTM E 136, Standard
Test Method for Behavior of Metals, in a Vertical Tube
Furnace at 750° C
C. Combustible Materials
Materials made of or surfaced with any of the following
materials:
- Wood - Compressed paper
- Plant bers - Plastic
Any material that can ignite and burn; ame proofed or
not, plastered or un-plastered
Heatilator • A36C & A42C • 28396 • Rev AG • 11/08
A. Appliance Certi cation
This replace system has been tested and listed in accor-
dance with UL 127 and ULC-S610 standards by Under-
writers Laboratories Inc. for installation and operation in
the United States and Canada.
This replace may be installed in sleeping rooms EX-
CEPT in manufactured homes. If installed with a gas log
set, provisions for the National Fuel Gas Code must be
met.
This replace has been tested and listed for use with the
optional components speci ed in this manual. These op-
tional components may be purchased separately and in-
stalled at a later date. Installation of an outside air kit will
require signi cant reconstruction and is best if installed at
the time of replace installation.
Heatilator is a registered trademark of Hearth & Home
Technologies Inc.