Filter
Top Products
Heat & Glo • 8000TR-OAK, 8000TR-OAK-IPI, 8000TRLP-OAKIPI • 2057-900 Rev. P • 11/08 37
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
A. Top Vent
9
9
Appliance Preparation
Figure 9.2 Remove the center insulation plug.
Figure 9.3 Cut the metal retaining band and fold the
sides out.
Figure 9.4 Fold the center parts of the retaining band up
and use to remove the seal cap.
Figure 9.5 Discard the seal cap, remove and discard
the insulation basket. Note: Once the vent cap has been
removed it cannot be reattached.
Proceed to Section 10.
Figure 9.1 Remove the cover plate by removing the four
screws holding it to the top of the appliance. Remove and
discard the cover plate.