Filter
Top Products
16 PC 45 Corn/Pellet Stove
MANUAL START UP
Starting the Fire
Igniter Switch to"MANUAL"
(down position)
Make sure the unit is plugged into a 120 VAC, 60
HZ electrical source. The power light should be the only
light lit. Anytime there is interruption in power at the
receptacle, the combustion blower will run for 1 minute
after the power is regained.
Burning Corn
1. Turn the Feed Adjuster to desired feed rate, approximately #2.
2. Turn the Mode Selector to "OFF" and then to the desired
mode. This will reset the control and start the combustion
motor.
3. Turn the Temperature Dial to the desired setting.
4. Clean the burnpot and housing, if necessary.
5. Fill the burnpot with corn up to the auger shaft. Then place
pellets on top of the corn as high as the shelf area. See corn
burnpot shown on left.
6. Add starting gel on top of the pellets, stir gel into the pellets
and corn for faster lighting.
7. Light the starting gel with a match and close the door.
Operation will begin when the fire reaches the proper
temperature.
8. Fill the hopper with corn and remove the ashes as required.
Burning Pellets
Optional pellet burnpot required to burn pellet fuel.
1. Turn the Feed Adjuster to the desired feed rate,
approximately #4.
2. Turn the Mode Selector to "OFF" and then to the desired
mode. This will reset the control and start the combustion
motor.
3. Turn the Temperature Dial to the desired setting.
4. Clean the burnpot and housing, if necessary.
5. Fill the burnpot with pellets so that the auger tube opening
is covered and slopes away from the auger tube opening.
See pellet burnpot shown on left.
6. Add the starting gel on top of the pellets. Stir the gel into
the pellets for fast lighting.
7. Light the starting gel with a match and close the door.
Operation will begin when the fire reaches the proper
temperature.
8. Fill the hopper with pellets and remove the ashes as
required.
Fig. 26
Corn Burnpot
Optional Pellet Burnpot
"NEVER USE GASOLINE, GASOLINE-TYPE LANTERN
FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR
SIMILAR LIQUIDS TO START OR "FRESHEN UP " A FIRE
IN THIS HEATER. KEEP ALL SUCH LIQUIDS WELL AWAY
FROM THE HEATER WHILE IN USE".
Warning
Fig. 27
Fig. 28
Shut-Down Procedure
To kill the fire or stop burning the stove, turn the Mode
Selector to "OFF". This will cause the fire to diminish and burn
out. When the fire burns out and the stove cools down every-
thing will stop. NOTE: The combustion blower motor will
run for 5 hours after the stove is completely cool. This in-
sures that all fuel in the burnpot and ashes located in the ash
pan are completely cold before shut down of the combustion
motor.
If you pull the plug to shut down the stove, all motors will
stop. This may cause incomplete combustion and smoke in the
firebox. If the load door is opened the smoke may escape.
The best way to shut down the stove is simply let it run out
of fuel, then the stove will shut down automatically.