Filter
Top Products
19
Inspect the hopper lid sponge gasket. It is important
to maintain a good hopper lid seal.
Do not allow pellets or sawdust to remain
on the hopper lip after filling.
Control door finger
hole
Draft Meter hex plug
HI-LO Distribution blower speed
range switch
Maintenance - Cleaning Glass on View Door
The unit should be out and cool to clean the door glass. It may not always be possible to allow
the unit to cool off before cleaning. Therefore, if the unit is turned to the lowest setting about 1 hour
before cleaning, it will make it possible to clean the glass with the unit in operation.
Any glass cleaner with a high amonia content will work the best. Use only non-synthetic cleaning
rags such as cotton or paper towels.
CAUTION: Take care when spraying cleaner on the side surface of the glass. The glass may be
hot enough to cause undesirable fumes to fill the area around the unit very rapidly. Gloves and
eye protection are recommended.
Glass Gasket
Replace glass
only with high
t e m p e r a t u r e
ceramic glass.
Inspect door gasket during
cleaning and inspection
Fig. 34
Evaluation notes were added to the output document. To get rid of these notes, please order your copy of ePrint IV now.