Filter
Top Products
23
Save These Instructions 3-90-798 Dry Seasoned Wood Only!
The optional blower kit #1-00-797032 installs easily to
the rear of the Oakleaf.
Hold the blower assembly into place and secure it with
the two bolts provided. You'll need a 3/8" wrench or
socket to tighten the bolts.
Loosen the eight screws to remove the rear shield.
Raise the shield to the upper set of holes, re-install the
shield, and tighten the screws.
Whenever a rear vent conguration is used, the upper
rear heat shield, #1-00-797066 must be purchased
and installed, to accomodate the ue collar. There
are eight screws that secure the existing shield. You'll
need to break away the tabbed portion of the lower
shield ue cut-out. Remove the screws from the top-
vent shield and install the rear vent shield in it's place.
Height adjustment for blower use is done the same
as with the top-vent shield in place. See D. Optional
Blower Installation (above) for detailed instructions.
Part #1-00-797058 be purchased and installed
whenever the Oakleaf is installed on a protected
combustible oor. The shield installs on four bolts that
are protruding downward from the base of the stove
body. Slide the shield under the stove from the back,
as this is the only way it will t. Lift into place guiding
the bolts through the holes in the shield and secure
with the nuts that are included with the shield.
Plug the blower into a properly grounded electrical
outlet.
You can turn the blower on at any time using the rocker
switch on the rear of the blower housing. Setting the
switch to "AUTO" will keep the blower off until there
is a signicant amount of heat from the stove. In this
setting, the blower will also shut off when the stove
cools. Keep the blower on low speed or off during low
res. As you get out of the low burn range, the speed
can be set wherever desired, or kept off.