Filter
Top Products
SKU 94799 For technical questions, please call 1-800-444-3353 Page 5
7. Peel the Adhesive Pad backing from one of the Magnetic Strips and mount it
parallel to, and no more than 1/4 inch from, the Sensor. See photos at the
bottom of page 4.
8. Repeat steps 5 to 7 for each Sensor and Magnetic Strip.
9. Using a small round-head screw (not supplied), screw into the desired
mounting location. Place the hole in the back of the Main Unit over the screw,
and slide the unit down to lock in place.
Note: Not all the Sensors need to be used for the Wireless Home Alarm to work.
Operation
Controls and Indicators
Setup for Operation
1. On each Sensor, push the slide switch to the desired operating position:
RF+Alarm (signal and sound) or RF (signal, no sound).
2. On the Main Unit, push the slide switch to the desired operating position:
Alarm (loud noise) or Chime (Ding-dong sound).
Main Unit
Sensor
Sensor LED lights
when Sensor tripped.
Alarm - Loud noise
when Sensor tripped.
Chime - Ding-dong
sound when Sensor
tripped.
Off - Unit turned off.
Off - Sensor turned off.
RF - Sensor On; No
sound when tripped.
Sensor # lights on
Main Unit.
RF+Alarm - Sensor On;
Sensor Sounds when
tripped. Sensor # lights on
Main Unit.