Filter
Top Products
SKU 94799 For technical questions, please call 1-800-444-3353 Page 4
2. Unscrew the back cover of each Remote Control and insert the battery
(supplied) into the back of the Remote. Pay attention to the battery polarity
(+ and -). See photo below-right.
Note: Each Sensor comes with a battery installed. Since the internal battery is only
used when the Magnetic Strip is moved away (sensor tripped), it should last two
years. The batteries of the Remote Controls should also last two years.
3. Select the six Sensor locations. They should be placed in the most likely point
of entry, (i.e., doors or windows), or exit points, if used to protect entry to
areas such as to swimming pools.
4. Select an area on the movable part of the door or window where the Sensor
can be mounted flat. The Magnetic Strip must be mounted parallel to, and no
more than 1/4 inch from, the Sensor. The Sensor and Magnetic Strip may be
mounted upside down to accommodate door or window configuration.
Note: It is recommended to test each Sensor with its Magnetic Strip before mounting.
Refer to the Operation section on page 5.
5. Peel off the backing to one of the Adhesive Pads and squarely stick it to the
back of one of the Sensors.
6. Peel off the remaining Adhesive Pad backing and secure the Sensor to its
mounting location.
Main Unit
Remote Control
Window Frame
Window
Door Frame
Door