Filter
Top Products
SKU 93762 For technical questions, please call 1-800-444-3353. Page 18
Basic Bandsaw Operation --
Vertical Position:
1. WARNING! Always wear ANSI-
approved safety impact eye goggles
when operating the Bandsaw.
Do not plug the Power Cord Plug 2.
into an electrical outlet until all
necessary adjustments (as previ-
ously discussed in this manual)
have been made.
FIGURE S
SAW BLADE
(82)
VERTICAL CUTTING
PLATE (189)
POWER SWITCH (164)
BODY
FRAME
(60)
SUPPORT
PLATE (150)
LOCKING
PIN (153)
3. Raise the Body Frame (60) to its full
vertical position, making sure it locks
in place by turning the Support Plate
(150) to the right until it rmly locks
into the Body Frame and inserting the
Locking Pin (153). (See Figure S.)
Once all necessary adjustments to 4.
the Bandsaw have been made, plug
the Power Cord Plug into the near-
est 120 volt, grounded, electrical
outlet.
Turn the Power Switch (164) to its 5.
“ON” position. (See Figure S.)
6. CAUTION! Cut only at workpiec-
es when the Bandsaw is in its vertical
position. Never attempt to cut pipes
or other round objects with the Band-
saw in its vertical position.
Before cutting, turn on the Bandsaw 7.
and check for excessively loose Saw
Blade (82) tension or machine vi-
bration. If this is found, turn off the
Bandsaw and correct the problem
before using. (See Figure S.)
Set the workpiece on the Vertical Cut-8.
ting Plate (189), making sure to keep
downward pressure on the workpiece
throughout the cutting process.
(See Figure S.)
When cutting a large workpiece, 9.
make sure its entire length is properly
supported. If necessary, use a roller
stand (not included) with a larger
workpiece.
Allow the Saw Blade (82) to turn up 10.
to full speed before feeding the work-
piece into the Saw Blade.
(See Figure S.)
11. WARNING! Keep hands and
ngers safely away from the cut-
ting area.
Feed the workpiece into the Saw 12.
Blade (82) gradually. Do not force
the Bandsaw to remove material
faster than it is designed to cut.
(See Figure S.)
Never attempt to remove mate-13.
rial stuck in the moving parts of the
Bandsaw while it is plugged in and
running. Turn off the Bandsaw if the
workpiece is to be backed out of an
uncompleted cut.
Once the cut is made, turn the Power 14.
Switch (164) to its “OFF” position.
Then, unplug the Power Cord Plug