Filter
Top Products
SKU 93662 For technical questions, please call 1-800-444-3353. Page 7
ASSEMBLY INSTRUCTIONS
CAUTION! Always make sure the Power Switch (98A) of the Engine is in its “OFF”
position prior to performing any service, maintenance, or cleaning of the Water
Pump or Engine.
To Add Engine Oil:
IMPORTANT! 1. Prior to rst using the Water Pump, the Engine MUST be lled with
a high quality 10W-30 grade engine oil. (See Figure A.)
MAXIMUM OIL LEVEL
MINIMUM OIL LEVEL
OIL DIPSTICK (65A)
FIGURE A
2. To do so, unscrew and remove the Engine Oil Dipstick (65A). Pour approximately
2/3 quart of engine oil into the Dipstick Hole. Do not overll. (See Figure A.)
Clean the Oil Dipstick (65A). Then screw the Dipstick fully back into the Dipstick 3.
Hole. Unscrew and remove the Oil Dipstick again, and observe the level of en-
gine oil on the Dipstick. The oil level should appear between the “MINIMUM” and
“MAXIMUM” indicator marks on the Oil Dipstick. (See Figure A.)
4. If necessary, continue adding engine oil, while rechecking the Oil Dipstick (65A),
until the oil level reaches the “MAXIMUM” indicator on the Oil Dipstick.
Do not exceed the “MAXIMUM” indicator mark on the Oil Dipstick.
(See Figure A.)
5. When nished adding engine oil, carefully screw the Oil Dipstick (65A) back into
the Dipstick Hole. (See Figure A.)