Filter
Top Products
Page 2SKU 39860
For technical questions, please call 1-800-444-3353.
THANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please complete the
owner’s record below:
Model________ Serial No. Purchase Date
SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you read the entire
manual to become familiar with the unit BEFORE you begin assembly.
Technical Specifications
Tool Name: 13” Industrial Planer
Item Number: 39860
Motor: 3 HP, 220 V~, 60 Hz, Single Phase, 3450 RPM
Cutter Head: 5200 RPM
Maximum Depth of Cut: 3/16”
Stock Capacity: 6-1/4” H x 13” W
Cutter Head: 2.289” Diameter
Feed Rate: 13 FPM
Blade Dimensions: 13-1/16” x .795” x .015”
Table Dimensions: 19” L x 12-1/8” W
Accessories: 8 mm - 10 mm Combination Wrench, 3 mm Hex Wrench,
5 mm Hex Wrench, 6 mm Hex Wrench
Warning: The warnings, cautions and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must
be understood by the operator that COMMON SENSE AND CAUTION ARE
FACTORS WHICH CANNOT BE BUILT INTO THIS PRODUCT, BUT
MUST BE SUPPLIED BY THE OPERATOR.
The Operator
PLEASE REMEMBER:
Do not operate the product if under the influence of alcohol or drugs. Read warning labels on prescriptions to
determine if your judgment/reflexes might be impaired.
Do not wear loose clothing or jewelry as they can be caught in moving parts.
Protective gloves and non-skid footwear are recommended.
Wear restrictive hair covering to contain long hair.
Use eye and ear protection. Always wear ANSI-approved impact safety goggles and dust mask or respirator
when working around metal, wood and chemical dusts and mists. Wear a full face shield if your are producing
wood filings.
Always stand off to one side of the machine.
Do not reach over or across running machines.
Maintain proper footing and balance at all times.
Do not abuse the power cord. Do not yank on cord to disconnect it from outlet. Keep the cord away from
heat, oil and sharp edges.
REV 03d; 06b