Filter
Top Products
3
Product Specification
Minimum incoming water pressure 21.75 psi
Recommended incoming water pressure 29 - 72 psi
Max. hot water temp 176
o
F*
Recommended hot water temp. 120
o
F - 140
o
F*
Max. flow rate handshower 2.5 gpm
bodysprays < 1 gpm each
Supplies 1/2” NPT hot and cold
Protection against back siphonage provided by check valves in handshower outlet, and in the hot
and cold supply elbows. The check valves should be removed and inspected yearly.
This showerpanel is for installation on a flat wall only. It is not possible to mount it in a corner.
*Know and follow all applicable local plumbing codes when setting the temperature on the water heater. In Massachussets,
the water heater may be set no higher than 112
o
F.
Necessary Tools for Installation (not included):
level
measuring device
grease pencil
8 mm drill bit
10, 22, and 24 mm wrenches
2 mm Allen wrench
mallet
waterproof sealant
pliers
Box Contents
Open the box carefully. Take care not to lose or
damage any of the component parts. Make sure
that all parts are present and are in good condi-
tion. If a component is missing or damaged,
contact Hansgrohe Technical Services.