4
Rough-in
Install 1/2” NPT male nipples at the positions shown on the rough-in diagram for the hot and
cold water supplies.
The nipples should extend 5/8” outside the surface of the finished wall.
Install the finished wall surface. Make the wall watertight.
The showerpanel will hang on the finished wall.
The measurements shown on page 5 are for the suggested installation shown on page 3,
which is ideal for users of approximately 5’11” in height. The minimum ceiling height for this
installation is 86 5/8”.
The panel height may be increased if desired. The measurements shown on page 5 must be
increased accordingly, including the minimum ceiling height.
Thoroughly flush the hot and cold water supplies before installing the showerpanel.
•
•
•
•
•
•
•
Package Contents
Please check the package contents before beginning installation. If parts are missing or are not in
good condition, please contact Hansgrohe Technical Service.