Filter
Top Products
6
c. Working with the Floor Brush
Attach the large floor brush to the end of the tube. The large floor brush has a pedal that toggles
with two positions. The top of the floor brush is equipped with a pedal which allows you to clean
different floor-types:
- Position 1: The bristles are exposed on the bottom of the brush.
Use this to clean hard floors (wood, tiles, etc). Press the pedal on the floor brushes to
get the bristles out. This will prevent scratching the floor. (Fig. 4/1.1)
- Position 2: The bristles are retracted and bottom of the brush is smooth.
This is used to clean carpet. Press the pedal on the floor brush to the other side to
retract the bristles, allowing the floor brush to slide smoothly over the carpet.
(Fig. 4/1.2)
d. Storage of Power Cord
After you have finished using the vacuum, unplug the unit and press the cord release button to
rewind the cord into the unit. Hold the plug to prevent it from whipping while rewinding and use
your hands to carefully guide the cord if necessary.
e. Carry Handle
Use the carry handle located at the rear end of the vacuum cleaner to move the unit from room
to room.
f. Park Position
A parking slot can be found on the left faux wheel of the
vacuum cleaner (a), where the floor brush tool and hose can
be parked for carrying & storage (Fig. 4/2). There is a plastic
channel located close to the base of the floor brush tool (b).
Slide the channel into the slot located on the left side of the
vacuum. Hold the extension tube when lifting and moving the
vacuum in this position.
Fig 4/1.1 Fig 4/1.2
Fig 4/2
b
a