Filter
Top Products
8
b. Cleaning the Canister Separator
1. Twist and pull the dust container bin from the canister separator (Fig.6/3).
2. The separator should be cleaned with a soft brush and wiped with a damp cloth.
The dust container bin may be wiped clean (Fig. 6/4).
3. Allow the separator to dry completely for 24 hours before replacing.
NOTICE: The separator should not be submerged in water. Do NOT use any
detergents. It is recommend to clean the filter every time you empty the dust
container.
4. Reassemble the dust container and canister separator.
c. Cleaning the Pre-Motor Filter
Note: This is located above the dust container bin. Release the pre-motor filter cover by twisting
the dust container bin’s cap. Lift off the cap to gain access to the filter (a). Remove the filter by
lifting it (Fig. 6/5).
Fig 6/3
Fig 6/4
Fig 6/5