Filter
Top Products
3
3
Connect each wire to the terminal strip(s) on the thermostat base per the wiring diagram for your system
application - See Figures 4 - 7. Form the thermostat wiring so that the cable lies flat between the terminal
strip(s) and the center of the base - See Figure 2.
If a remote system or temperature sensor is being used with the thermostat, connect the remote system or
temperature sensor wiring per the diagram for the application - See Figures 8 - 10.
Upon completion of wiring the thermostat, push all excess wiring into the hole in the wall. Plug the hole with
the supplied insulating foam to ensure an accurate temperature reading by the thermostat.
Align the tabs of the thermostat face with the slots of the thermostat base. Gently push the thermostat face into
the thermostat base locking it into place - See Figure 2.
Wall
Base
Tab
Slot
Temperature
Sensor
Figure 2 Figure 3
Note:
Be sure that the thermostat temperature sensor is standing up, and that it has not been damaged during
installation - See Figure 3.