Filter
Top Products
Page 71
FEDERAL COMMUNICATION COMMISSION NOTICE:
1. This equipment complies with Part 68 of FCC Rules. On the door, inside of the OmniPro II enclosure, is a label that
contains, among other information, the FCC registration number and Ringer Equivalence Number (REN) for this equipment.
If requested, provide this information to your telephone company.
2. An FCC compliant telephone cord and modular plug is provided with this equipment. This equipment is designed to be
connected to the telephone network or premises wiring using a compliant modular jack which is Part 68 compliant. See
installation instructions for details.
3. The REN is useful to determine the quantity of devices you may connect to your telephone line and still have those devices
ring when your number is called. In most, but not all areas, the sum of RENs of all devices should not exceed five (5). To
be certain of the number of devices you may connect to your line, as determined by the REN, you should call your telephone
company to determine the maximum REN for your calling area.
4. If your OmniPro II system causes harm to the telephone network, the telephone company may disconnect you service
temporarily. If possible, they will notify you in advance. You will be advised of your right to file a complaint with the
FCC.
5. Your telephone company may make changes in it's technical operations, facilities, equipment, or procedures; if such changes
affect the compatibility or use of this device, the telephone company is required to give adequate notice of changes so as to
give you an opportunity to maintain uninterrupted service.
6. In the event of equipment malfunction, all repairs should be made by our company or an authorized agent. It is the
responsibility of users requiring service to report the need for service to our Company or to one of our authorized agents.
Service can be obtained at:
HOME AUTOMATION, INC.
5725 POWELL STREET
SUITE A
NEW ORLEANS, LA 70123
7. This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject to
state tariffs. (Contact your state public utility commission or CORPORATION commission for information.)
8. This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance
with the manufacturer's instructions, may cause interference to radio and television reception. This device complies with
Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference, including interference that may cause undesired operation.
Part 15 of FCC Rules are designed to provide reasonable protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
interference to radio or television reception, the user is encouraged to try to correct the interference by one or more of the
following measures:
1. Reorient the receiving antenna.
2. Plug the receiver into a different outlet. If necessary, the user should consult the dealer or an experienced
radio/television technician for additional suggestions.