Filter
Top Products
39
If you have a question about any special order item,
just call 1-800-543-GATE!
11" Push to Open Bracket (FM148)
Required when Mighty Mule® 500/502 gate opener(s) must push the gate open, such as on a sloping driveway
or where space prevents gate(s) from opening inward (pulled open). Order two PTO brackets for conversion
of a dual swing gate installation.
Column Mount Lock Receiver (433IH)
For mounting the Automatic Gate Lock on brick columns, walls, or for other applications with limited space
between gate and post.
Replacement Transformer (RB570)
Standard 18 volt AC transformer for maintaining the battery included with the Mighty Mule® gate opener.
This is the only transformer approved for use with all UL325 Mighty Mule® gate opener systems.
Garage Door Receiver (RB709)
The Garage Door Receiver allows you to use the same Mighty Mule® entry transmitter (see Dual and Triple
Transmitters) to operate your gate opener and your garage door opener. Compatible with most garage door
openers.
#41 Slide Gate Chain (RB207)
The #41 chain (32’ only) is used with the GTO/PRO SL-1000/1200 and SL-2000/22000 DC Slide Gate
Operators.
HEDDOLF
UNIVERSAL
RECEIVER
MODEL 294
Replacement Battery (RB500)
Standard 12 volt, 7.0 amp-hour, maintenance-free battery for the PRO-SL1000/2000 gate operators. This battery
is approved for use with the PRO-SL1000/2000 gate operators. Life expectancy is 3-5 years.
GTO/PRO 24 Amp Hour Battery Kit (FB295)
This large 12 volt, 24 ampere-hour, maintenance-free battery is for the GTO/PRO SL-2000&2200 gate
operators. It will supply additional power for increasing the number of open and close cycles of the GTO/PRO
SL-2000&2200 operators. The kit comes with the battery, battery pan and wiring harness for easy installation
inside the existing operator housing. This battery is approved for use with GTO gate operators. Battery life
3 to 5 years.
Low Voltage Wire (RB509)
The 16 gauge, multi-stranded, dual conductor Low Voltage Wire is for connecting the AC powered transformer,
or the Solar Panel to the control board. Also used for the connection of accessories, such as locks, keypads,
push buttons and other wired control devices. This specially designed wire is UV treated, PVC coated and
ready for direct burial. Available in 1000' rolls or special lengths.
ACCESSORIES AND PARTS AVAILABLE FROM YOUR RETAIL STORE (CON'T)
The contents of all material available on this installation manual are copyrighted by GTO, Inc. (“GTO”), unless otherwise indicated. All rights are reserved by GTO, and content may not be reproduced,
downloaded, disseminated, published, or transferred in any form or by any means, except with the prior, written permission of GTO. Any reprinting of GTO publications is by permission only. Copyright
infringement is a violation of federal law.
Mighty Mule¨, E-Z Gate¨, GTO¨, are registered trademarks of GTO, Inc. America’s DIY Automatic Gate Openers is a trademark of GTO, Inc. and are the exclusive property of GTO, Inc. (“GTO”).
All rights are reserved by GTO, and these marks may not be used, in any for without the prior, written permission of GTO.