Filter
Top Products
GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is red and located inside the packaging taped to the top box. Be sure you DO
NOT discard any pieces.
Step 1
Locate the hearth and place it on the floor. Do not put it up
against the wall at this point in the assembly as you need
to get in behind the mantel to insert several screws.
Step 2
Locate the 2 base shelves. Standing in front
of the hearth, place them with the finished side up on
the bottom of the left and right side hidden storage compartments.
Step 3
Locate the left inside and left outside wall panels,
the back panel and the top panel for the left
hidden storage compartment.
Locate the bag of plastic shelf supports. Insert 8
supports into the holes on the inside of both the
inside and outside wall panels.
NOTE: It is much easier to do this step before
you have built the hidden storage compartments.
Now position both the inside and outside wall
panels so that the bottom fits underneath the base
shelf. Slide the back panel (finished side inside the
compartment) between the side panels ensuring
that the back panel stays in position within the
grooves on both side panels. Get your helper to hold the panels snuggly in place while you insert
the 6 bottom screws which will hold the sides and back in position.
Position the top shelf in place. Ensure the compartment back is fitted into the groove on the top shelf.
Get your helper to apply pressure to the side to eliminate any gaps while you insert and tighten the
top 6 screws. You are now ready to insert the 4 shelves onto the shelf supports to complete the
storage compartment.
Step 4
Repeat Step 3, but with the right inside and right outside wall panels.