Filter
Top Products
Step 6
Locate the right inside and outside wall panels for the right wine cooler
storage compartment. Place them around the bottom panel (already in
place) on the hearth. Get your helper to hold these pieces in place
while you insert and tighten the 6 bottom screws. Position the top panel
in place. Get your helper to apply pressure to the side to eliminate any
gaps while you insert and tighten the top 6 screws.
Step 7
Take your electric firebox out of its packaging and position
it between the 2 storage compartments. Ensure the plug is
at the back of your mantel, ready to be plugged in before
you position your mantel in place up against the wall. The
firebox does not get attached to the mantel in any way ….
it just sits there.
If you have any questions about the firebox please reference
the installation instructions that come with the unit. Please
reference the Quick Tips section of that instruction manual.
Step 8
Locate the header piece that will be attached to the left and right storage compartments and will sit
above the firebox. Position the header with the finished side facing the front of the mantel. Insert and
tighten the 4 screws which will hold the header in place.
CAUTION
DO NOT USE AN ELECTRIC DRILL TO INSERT
THESE SCREWS. A POWER DRILL CAN DRIVE
THE SCREWS THROUGH THE FACE OF THIS
PANEL THIS SHOULD NOT HAPPEN WITH A
MANUAL SCREW DRIVER. BE CAREFUL.