Filter
Top Products
GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is red and located inside the packaging taped to the top box. Be sure you DO
NOT discard any pieces.
Step 1
Locate the hearth and place it on the floor. Do not put it up
against the wall at this point in the assembly as you need
to get in behind the mantel to insert several screws.
Step 2
Locate the left and right bottom plates. Standing in front
of the hearth, place them with the finished side up on
the left and right sides of the left and right side storage compartments.
Step 3
Locate the left inside and left outside wall panels, the back
panel and the top panel for the left wine bottle storage compartment.
Position both the inside and outside wall panels, position the back
panel (finished side inside the compartment) by inserting the panel in
the groove of one side, then squeezing the sides together ensuring
that the back panel stays in position within the grooves of both side
panels. Get your helper to hold the panels snuggly in place while
you insert the 6 screws which will hold the sides and back in position.