Filter
Top Products
Flush Pump Before Installing Kit
2 309911C
Flush Pump Before
Installing Kit
See FIG. 1. Flush component A (ISO) side from pump A
inlet (C) to PRESSURE RELIEF/SPRAY valve (SA) on
Reactor fluid manifold. See Reactor operation manual
for details.
Tools Required
• 12 in. adjustable wrench
• 1/4 in. open end wrench
• 7/16 in. open end wrench
• 13/16 in. open end wrench
• 7/8 in. open end wrench
• non-sparking hammer
• channel locks
• dropcloth and rags
• vise with soft jaws
• thread sealant
WARNING
Read warnings in Reactor operation manual. Flush
equipment only in a well-ventilated area. Do not spray
flammable fluids. Do not turn on heaters while flushing
with flammable solvents.
F
IG. 1
TI2602a
C
SA