Goodman Mfg 10.3 EER Air Conditioner User Manual


 
2 www.goodmanmfg.com SS-GPCC
PRODUCT SPECIFICATIONS
NOMENCLATURE
Unit Type Engineering
PCC Packaged Revisions
Air Conditioner
Nominal Capacity Electrical
090 90,000 BTU/h 3 208-230/3/60
120 120,000 BTU/h 4 460/3/60
3
5
A
6
PCC
1, 2, 3
120
4
ACCESSORIES
THERMOSTAT (CHT90-120)
Two-stage cool / two-stage heat thermostat with subbase,
manual changeover, fan-on or auto. Note: A variety of
thermostat con gurations can be used on this equipment
based on the application needs. For example, our CHTS36-
60 can be used if two-stage cooling and single-stage
heating is desired.
ROOFTOP LIFT KIT (RLK90-120)
Kit consists of four ½” shackles that are used to lift the
equipment into position on a roof, etc. The shackles are
attached to the mounting holes in the base rails. Wire or strap
material along with eld-supplied spreader bars are employed
to complete the lifting assembly (see rigging detail).
LOW AMBIENT CONTROL (LA-01)
Liquid temperature- (or pressure-) operated solid-state
control that varies the speed of one of the condenser fans.
Low ambient control reduces fan motor RPM as liquid
temperature (or pressure) decreases. Caution: If control
is used below 50 °F, accumulators should be added to the
equipment to avoid slugging of the compressors.
ROOF CURB (PGC-5)
Full perimeter curb for equipment in the down discharge
application. Curb includes provisions for duct attachment
prior to setting unit. Curb is shipped knocked down with all
necessary hardware and gasket material.
MANUAL AND MOTORIZED FRESH AIR DAMPERS (PGMD-5 & PGMDM-5)
Manual damper is xed position type for 0% to 25% fresh air.
Motorized damper is a eld-adjustable mechanical damper for
0% to 25% fresh air. Damper automatically closes when blower
stops.
ECONOMIZERS : (PGED090/102-5A & PGED120/180-5A,
PGEH090/102-5 & PGEH120/180-5)
Fully modulating, enthalpy-controlled economizers
shipped with major components pre-assembled. Plug
assembly on equipment and economizer provides easy
foolproof wiring.
HORIZONTAL DUCT KIT (PGHDK090/102-5A & PGHDK120/180-5A)
The unit is shipped in the down ow (vertical) duct con-
guration. The horizontal duct kit must be installed in
the eld for horizontal duct con guration.
PANEL LOUVER KIT (PLK090/102-5 & PLK120/180-5)
Louvered panels for condenser coil protection.
HEAT KIT ACCESSORY
Slide-in heat kit from 20kW, 30W and 40kW can be used
in 7½- to 10-ton models.