10
Specifications
Model LP1000
High-Pressure Plunger Pump
Volume ..................................................................................................3.4 GPM (12.8 LPM)
Maximum Discharge Pressure .............................................................14,500 PSI (1000 Bar)
Maximum Inlet Pressure ......................................................................Up to 90 PSIG (1305 Bar)
RPM .....................................................................................................1000
Plunger Diameter ..................................................................................22mm
Stroke ....................................................................................................42mm
Crankcase Oil Capacity ........................................................................118 fl. oz. (3.5 Liters)
Temperature of Pumped Fluids.............................................................Up to 104
o
F (40
o
C)
Inlet Port ...............................................................................................2 x 1/2" BSP
Discharge Ports ....................................................................................2 x 3/8" BSP
Shaft Rotation .......................................................................................Towards fluid end only
Weight ...................................................................................................143 lbs. (65 KG)
LP1000 HORSEPOWER CHART
RPM
GPM
7250 PSI
10,000 PSI
12,500 PSI
14,500 PSI
600
2.0
10.4
14.3
17.9
20.7
700
2.4
12.4
8.3
21.4
24.9
800
2.7
14.0
9.3
24.1
28.0
900
3.0
15.5
10.3
26.8
31.1
1000
3.4
17.6
11.7
30.4
35.2
3.1
HORSEPOWER RATINGS:
The rating shown are the power
requirements for the pump. Gas
engine power outputs must be
approximately twice the pump
power requirements shown above.
We recommend a 1.15 service factor
be specified when selecting an
electric motor as the power source.
To compute specific pump horse-
power requirements, use the Follow-
ing formula:
HP = (GPM X PSI) / 1400