Filter
Top Products
©2010 The Genie Company 01/27/2010
3
INTELLICODE
®
2 Access Security System
A new generation superior encryption system that enhances the security of the door opener by continuously
changing the access code each time the remote is used. The door opener responds to each new code only once.
An access code copied from a working system and tried again will not control the door opener.
OPENER FEATURES
Wall Console
Operates door opener from inside garage. Indicator Light with: Open/Close, Vacation Lock, and Independent
Light Control buttons.
and Car2U
®
compatible. Refer to the programming instructions on page 9 and then
follow the HomeLink
®
or Car2U
®
instructions in your car owner’s manual.
SAFETY FEATURES
Safe-T-Beam
®
(STB) Non-Contact Reversing System
Puts an invisible beam across the door opening. The door stops and reverses to the full open position if anything
passes through the beam. LED indicator lights on the power head and on the STBs provide a self diagnostic code
if an operational problem exists.
Safe-T-Reverse® Contact Reversing System
Automatically stops and reverses a closing door within two seconds of contact with an object.
Automatic ForceGuard
™
Control
Automatically sets the minimum force required to fully open and close the door for maximum safety.
Watch Dog
™
Monitoring System
Monitors the Safe-T-Beam® system to ensure proper functionality and will automatically stop and reverse a
closing door if a problem is detected.
Automatic Lighting System
Two bulb lighting system supplies up to 200 Watts of light for safer evening exits and entries. Turns ON when
door is activated and automatically turns OFF 4 minutes later.
Manual Emergency Release
Manually releases door from door opener. Used during a power failure or other emergency to allow manual
opening and closing of door.
Ener-Genie™ Battery Back Up
Easily adjust the programming to reduce opening speed to a desired rate, optionally adjust limits and force, and
program new remotes.
SmartSet™ Electronic Programming
Easily adjust the programming to reduce opening speed to a desired rate, vary limits and force, and program new
remotes.
Integrated Motion Detection (Not available on all models)
Select units have motion detection built into the power head. Lights automatically turn ON when motion is
detected for much safer movement through the garage. Lights will turn OFF after 4 minutes of no motion.