Filter
Top Products
9
PENER ASSEMBLY
FOR HELP-1.800.354.3643 OR WWW.GENIECOMPANY.COM
1
NOTE: Three (3) piece rail assemblies are for a 7
foot high door.
Clear a workspace area to unpack and organize box
and contents for assembly.
1. There are 4 boxes inside the carton. Each box is
numbered 1 - 4. Note that some openers will
contain the same parts and be packaged with
fewer boxes. Carefully remove the three
internal boxes (Labeled #1, 2, and 3) and place
them on the floor for easy access (Fig. 1-1).
These boxes contain assembly parts and the
contents are organized by assembly tasks. For
quick reference inside the lid of each box there is
a label illustrating the components inside.
2. Remove the motor power head and place it on
the floor for later use. Remove box #4 and
place it on the floor for later use.
Do NOT run until opener is fully assembled and
instructed to do so.
CAUTION
FIG. 1-1 Internal boxes.
RAIL ASSEMBLY: Use a clean, flat surface.
Box Label Example
#4
To reduce the risk of injury to persons or
damage to property - Use this opener only
with sectional doors.
WARNING
NOTE: For 1-piece rail—skip to POWER HEAD &
RAIL ASSEMBLY.
IMPORTANT INSTALLATION INSTRUCTIONS
WARNING: To reduce the risk of severe injury or death:
1.
READ AND FOLLOW ALL SAFETY, INSTALLATION AND
OPERATION INSTRUCTIONS. (If you have questions or do
not understand an instruction, call the Overhead
Door Corporation.)
2.
Install only on a properly balanced sectional or one piece
garage door. An improperly balanced door could cause
severe injury. Have a trained door system technician make
repairs or adjustments to cables, spring assemblies, and
other hardware before installing the opener.
3.
Remove all ropes and remove or make inoperative all locks
connected to the garage door before installing opener.
4.
Where possible, install the door opener 7 feet or more above
the floor. For products having an emergency release, mount
the emergency release within reach, but at least 6 feet above
the floor to avoid contact with vehicles to prevent
accidental release.
5. Do NOT connect the opener to source of power until
instructed to do so.
6. Locate the wall console:
• Within sight of the garage door,
• At minimum height of 5 feet so small children
are not able to reach it, and
• Away from all moving parts of the door.
7. Install the Entrapment WARNING Label next to the
wall console in a prominent location.
8. After installing the opener, the door must reverse
within 2 seconds when it contacts a
1-1/2 inch high object (or a 2 x 4 board laid flat) on
the floor.
PN 37026501206 01/27/2012
Lag Srews
Rail Connectors
Rail Connector Bolts
Rail Connector Nuts
Bolts
Power head
Rail
5/16" Nuts
& Bolts
Header Bracket
Bolts
Header Bracket
Bag 2
Bag 3Bag 1
Bag 0