Filter
Top Products
16
3. Securely fasten wires.
• Securely fasten wires to ceiling and
wall using insulated staples provided.
– Use insulated staples.
– Staples should be snug only.
• If rear cover is attached to power head,
remove it.
• On power head:
– Route Wall Console wires through wire guide
on power head.
– Split and strip ends of wire (Fig. 3-2 on
previous page).
– Insert wire into terminal holes and lightly press in
the orange locking clips above each terminal
hole. (You can use a pencil or small screwdriver
to comfortably press in locking clips.) The white
wire into #1 terminal hole and striped wire into
the #2 terminal hole.
– Confirm wire lock by lightly tugging on the wire.
The wire should remain in the terminal hole.
• Do NOT install rear cover yet.
4. Mounting.
• Fasten Wall Console to wall with 2 screws
(provided) (Fig. 3-4).
• Remove protective backing from "Entrapment"
warning label (Fig. 3-5). The "Entrapment" label
is located in the center of this manual.
– Stick label on wall near Wall Console.
FIG. 3-4 Mounting Wall Console.
Child can be pinned under automatic garage
door.
Death or serious injury can result.
•
Never let child walk or run under moving door.
.
•
Neve
r let child use door opener controls.
•
Always
keep moving
door in sight.
•
If person is pinned, push control
button or use
emergency release.
•
Test door opener monthly:
Refer o your
owner
s manual
P
ace 1/- nch object (or 2x4
l
aid f at) on floor
If door a ls o reverse on con act
ad
just opener
If opener s i l a ls o reverse door repa
ir or replace opener
D
o not remo
ve or pa nt over his labe
l
Mou nt wal conrol out o f chid
s ea
c
h
(at leas t
5 f ee
t a bove loo
r)
Place ne xt o wal
l cont
rol
©19
9
9
Insulated
Staple
+ –
P B
Infared Sensor
FIG. 3-3 Insert wires
.
(Power Head With Rear Cover Removed)
Terminal
Holes
Locking
Clips
FIG. 3-5 Mounting Entrapment warning label.
3
2
1
Independent Light Control
–
Controls door opener lights from inside garage
–
Energy-Saver shut-off turns OFF lights 3 minutes after
door activation
Vacation Locking Switch
– LOCK disables controls after
door is completely closed
– UNLOCK allows controls to
work normally
Door Control "Open/Close" Button
–
Open and closes door from
inside garage
wire guide
PN 37026501206 01/27/2012