Filter
Top Products
18
3b. Wiring (pre-wired).
• Route wire from wall to Safe-T-Beam
®
sensors
(Fig. 4-5b).
• Splice pre-wiring to shortened sensor wire,
match wire pairs dash-to-dash (striped-to-
striped) and plain-to-plain (white-to-white).
- Trim sensor wire to approximately one foot
(1 ft) from sensor.
- Split and strip ends of sensor wires and
pre-wired wires (Fig. 4-7).
- Splice wires together with (provided)
wire nuts.
• Route wire from ceiling to power head
(Fig. 4-5b).
• Securely fasten wires where they exit
wall and ceiling as you go.
– Use insulated staples.
– Staples should be snug only.
4. Split and strip ends of sensor wires (Fig. 4-7).
NOTE: For rear cover locate Box 4.
5. Attach Safe-T-Beam
®
wire to power head wire
terminal.
• Route Safe-T-Beam
®
wires through wire guide
on power head.
– Insert wire into terminal holes and lightly press
in the orange locking clips above each terminal
hole. (You can use a pencil or small
screwdriver to comfortably reach in and lightly
press down locking clips.) Insert white wires to
'even' numbered terminal holes and striped
wires into 'odd' terminal holes (Fig. 4-8).
– Confirm wire lock by lightly tugging on the wire.
The wire should remain in the terminal hole.
• Do not install the white (lamp) cover at this time.
NOTE: Safe-T-Beam
®
alignment check must be
performed following connection to electrical
power (see page 19). DO NOT PLUG IN YET!
Staples which are too tight can cut or pinch wires.
Cut or pinched wires can cause the Safe-T-Beam
®
System to stop working. When using the insulated
staples, make sure you fasten them only as tightly
as needed to hold the wire snugly.
CAUTION
FIG. 4-7 Splitting and stripping
.
FIG. 4-6 Wire routing
.
Wire
Wire
Source or Sensor
Source or Sensor
Invisible Light Beam
Protection Area
Insert Wire
Into Connector
Use this
wire routing
if NOT pre-wired
Terminal
Holes
Locking
Clips
+ –
P B
Infared
Sensor
FIG. 4-8
Insert wires
.
(Power Head With Rear Cover Removed)
FIG. 4-5b Pre-Wired source and sensor wiring
methods
.
or
6 5 4 3 2 1
6 5 4 3 2 1
SensorSource
Power
Head
Dashed Line = striped wire
Solid Line = white wire
Wall Wall
Ceiling
1/2"
2"
Insulated
Staple
Wire Nut
wire guide
PN 37026501206 01/27/2012