Genie 1200/1500 Garage Door Opener User Manual


 
Optional Programming
4
Setting Up a PIN
1.
Press in order 3–5–7.
2.
Press the
Program key.
3.
Enter your new PIN (3-8 characters).
4.
Press
Program key.
Your keypad is ready for programming.
Programming
Locate Your Opener’s Programming Buttons and LED
Synchronizing Keypad to Opener
1.
Press and hold
Program Set key
for 2 seconds. (The round LED
turns blue and then goes o. The long LED will begin ashing purple
2.
Enter your PIN.
3.
Press
Up/Down key
. Opener LEDs will stay on steady.
Note:
For multiple doors, see the full instructions packed with the
keypad.
4.
Press
Up/Down key
again. Opener LEDs will turn o.
5.
Press
Up/Down key
again. Door opener will run.
NOTE:
Pressing any key will stop or start the opener while the door is in
motion. The door will automatically stop fully open or closed. When the
door has stopped moving, pressing on any single button will activate door
until backlight goes off (30 seconds)
NOTE:
Rapid blinking of the red LED on the Powerhead indicates an error.
When the blinking stops, you must start programming steps over.
Resetting PIN
If you have forgotten your PIN or you fear it may have fallen into
unauthorized hands, you must erase the old programming.
To erase, follow these simple steps:
1.
Press and hold
Program key
and then the
Up/Down key
for
5 seconds or until the LED starts to slowly blink. When blinking
stops you have successfully erased the old programming.
2.
Go back and follow the steps in
“Setting Up a Pin” and “Programming”.
Changing Your PIN
1.
Enter your current PIN, then press
Program key .
2.
Enter your new PIN, press
Program key .
Note:
If you are still having trouble with the keypad, refer to the full
instructions packed with the keypad.
PROGRAM
+
PROGRAM
SET
+
PROGRAM
SET
+
HOLD 2 seconds
Opener
Opener
HOLD HOLD
12
G999-393 Manual-ScrewBeltChain-EN indd 12 7/13/12 10 17 AM
PROGAMMING THE WIRELESS KEYPAD