Genie 1200/1500 Garage Door Opener User Manual


 
The Remote button is now programmed.
Repeat as necessary for additional Remotes.
To program the same Remote for other garage door openers, repeat
the steps above using one of the other two Remote buttons.
Each Remote can be programmed for three door openers.
BASIC PROGRAMMING IS COMPLETE AND YOUR GARAGE DOOR IS
READY TO USE!
NOTE: For Car2U and HomeLink, park the car outside the garage
with the ignition key in the “Accessory” position. Follow the Car2U or
HomeLink instruction to set the button in the car to Genie mode.
IMPORTANT: Your HomeLink® device
will ONLY respond to pressing THIS button
on your Intellicode remote when it's searching
to connect to your remote in "Learn Mode" as
described in the HomeLink® instruction manual.
Required Programming
3
PROGRAM
SET
PROGRAM
SET
18
Press and release the same button on the remote
(both LED’s flash blue and then turn off).
19
Press and release the same button on the remote
(the door should open or close).
11
G999-393 Manual-ScrewBeltChain-EN indd 11 7/13/12 10 17 AM