Filter
Top Products
Arming Your System When Leaving
1
Before armin
g
your system, make sure the
g
reen
Status
li
g
ht is ON. This indicates that all of your protective zones are
secure. If any zones are open, the correspondin
g
Zone number will be lit. Secure these zones before proceedin
g
. If any
zones cannot be secured, see Bypassin
g
zones below.
2
Enter your user code and press
.
The
g
reen
Status
li
g
ht will
g
o out, the red
Armed
li
g
ht will li
g
ht.
•
If you make a mistake enterin
g
your code, press , re-enter the code and press
.
•
If FIRE
is lit, the Fire zone has not been properly reset. Press , enter your user code and press
.
(See Silencing a Fire Alarm, page 8)
3
Leave the premises through the Exit/Entry door. If the keypad gives a steady tone you have taken too long. Enter your code
again to disarm system and then re-enter code and leave.
Easy Arm
The optional Easy Arm feature allows the system to be armed by simply pressing
.
This will allow the easy arming of the
system by someone who is not a regular system user.
Bypassing Zones
If an open zone cannot be immediately fixed it can be left unprotected, or
bypassed
,while the rest of the system is Armed.
To bypass a zone:
1
Press followed by the number of the zone to be bypassed. The bypassed zone’s number will flash slowly.
2
Enter your user code and press
.
The green
Status
light will go out and the red
Armed
light will light.
3
Leave the premises through the Exit/Entry door.
When the system is subsequently disarmed, all bypassed zones will be reset, ready to be armed again. If it is necessary to
bypass any inoperative zone(s), it is important to have the zone(s) repaired as soon as possible.
A bypassed zone does not provide any protection, compromising system security.
Arming Your System
5
Oi219c
page 5
Tuesday, September 16, 1997 08:24