Filter
Top Products
3.0 PUMP INSTALLATION
3.1 Inspection
Your pump was inspected and tested at the factory prior to shipment to ensure it
meets the requirements of your order. It is suggested the pump be checked upon
receipt for possible damage due to shipping. Any damage should be immediately
reported to the carrier.
3.2 Pump Mounting and Locations
The QSV Series pumps are intended for vertical mounting with the right angle inlet of
the pump down. See Figure 2 for correct orientation. The weight of the pump and
motor must be supported by setting the flat end of the outer housing on a rubber pad
supported by a plate or angle. Attach the pump to the frame work of your system
using ALL brackets included. Refer to Section 8.0 (Dimensional Drawing) for correct
bracket placement.
Figure 3.2
Right Angle Inlet and
Vertical Position
(QS2825V Shown)
5
Mounting Bracket
Right Angle Inlet