GE 71045 Vacuum Cleaner User Manual


 
7
How To Use
CAUTION: Do not plug in cleaner until you
understand all controls and
features.
1. Cord Retainer. To use, push electrical cord down into cord
retainer.
2. ON/OFF Switch. International symbol I means On,
International symbol O means Off.
3. Bag Cover Latch. When bag cover latch is pointing to the
left, the bag cover is unlocked. When bag cover latch is
pointing to the right the bag cover is locked. See the locked/
unlocked symbols on the unit.
4. Micron Filter Compartment. To open, slide micron filter
door up and pull away from unit. To close, place micron filter
door at top of opening pressing against unit, slide down into
place.
5. Bag Change Indicator. The bag change indicator is to remind
you to change the bag. The indicator on the bag cover moves
down the window as the airflow through the bag decreases.
NOTE: Certain types of fine particles like powder, plaster dust,
or fine road dust can restrict airflow very quickly. The
fine particles will decrease performance even before
the bag appears to be full. Change the dust bag to
restore maximum performance.
6. Disposable Dust Bag Compartment. To open, turn bag
cover latch (3) to the left pointing to unlock symbol, then
pull top of dust bag cover out and away from unit. To close,
place dust bag cover tabs (at the bottom) in groove at the
bottom of compartment, rotating dust bag cover up and
against unit. Then turn bag cover latch to the right pointing
to the lock symbol.
7. Stair Handle. To use when cleaning stairs.
8. Handle Release. Step on handle release. Pull handle back to
a comfortable position. Press release again to lower handle
further to clean under furniture.
9. Light Bulb Compartment. To gain access to light bulb
compartment remove the two screws in the lens.
10. Brush Roll Belt Window. To check condition of belt watch
to see if white dots on belt are moving through the window.
This indicates the brush roll is turning.
11. Screws to release hood. Remove these screws to release
hood and give access to brush roll belt area.
12. Cleaner Height Setting. The front of the cleaner has an
adjustment that raises or lowers the cleaner base to match the
type of floor surface. With the cleaner cord unplugged, set
the adjustment to lowest setting for maximum carpet cleaning.
If the cleaner is difficult to push, move adjustment to next
highest setting until cleaner is comfortable to push. The brush
roll must reach the carpet for effective cleaning. For ease in
moving the adjustment knob, place handle in operating
position and tilt cleaner back to remove weight from front
wheels.
WARNING: Avoid injury. Keep loose clothing, hair, fingers,
and all other parts of body away from any moving
part (such as the revolving brush). Turn off the
switch and unplug the cleaner before changing
the cleaner height setting.
13. Extension Wands. Use these wands on the end of the hose
for added cleaning reach.
1
12
11
11
10
9
8
7
6
2
3
4
5
13