Filter
Top Products
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support
About Your Heat Pump (6100 Series only)
Heat pumps can save money by removing heat
from the outside air—even when the outside
temperature is below freezing—and releasing
that heat indoors.
To get the best performance from your heat pump,
don’t change the room thermostat very often.
Raising the heat setting 2–3 degrees will cause
the Zoneline to use its electric heating elements in
order to reach the new temperature setting quickly.
There is a 3-minute minimum compressor
run time at any setting to prevent short cycling.
The indoor fan motor starts before the compressor
and stops after the compressor cycles off.
When the outdoor temperature is lower than 25°F,
heat is provided by the electric heater in the air
conditioner instead of by the heat pump.
The electric heating elements use much
more electricity than heat pumps and cost
more to operate.
About the controls on your Zoneline. GEAppliances.com
Controls
Temp Control
The temp control is used to maintain the room
temperature. The compressor will cycle on
and off to keep the room at the same level
of comfort.
Press the pad to raise the temperature.
Press the pad to lower the temperature.
NOTE: The display shows the set temperature,
not the room temperature.
Sleep
Press to set the air conditioner to run for 8hours
before it automatically returns to the previous
setting.
When in the cooling mode and the sleep timer
is set, the set temperature will automatically
increase 2°F after the second hour then 1°F
each hour over the next two hours. Also, the
fan speed will change to low. When in the
heating mode, the set temperature will
decrease in the same manner.
To cancel the sleep mode, press the MODE pad
or the SLEEP pad a second time.
Fan, Mode and Operation Control
FAN—Sets the fan operation for HIGH,
LOW or AUTO speed. When set at AUTO,
it automatically switches between LOW
and HIGH as room temperature changes.
MODE—COOL—For cooling
FAN—For fan-only operation
HEAT—For heating
OPERATION—ON/STOP—Turns the unit
on or off. Power remains connected to
the Zoneline. The Freeze/Heat Sentinel
features still function if active.See the
Freezer/Heat Sentinel section on page 6.
NOTE: The temperature display will flash
to indicate a possible unit malfunction. Set
operation control to STOP and then restart
the unit. If the flashing light reappears within
30 minutes, call for service.
Quick Heat Recovery
Activates each time the thermostat is switched from
STOP or COOL mode to HEAT mode. Electric heaters
are energized until the thermostat set point
is reached. On heat pump models, the heat pump
operation will resume at the next call for heat.
TEMP CONTROL
FAN, MODE & SLEEP OPERATION
3
▲
▼
+
–