Filter
Top Products
Problem Possible Causes What To Do
The air is not always The heat pump is not • This is normal. The heat pump will produce warm air
cool or hot during producing hot air. but not as hot as air produced when the higher-cost
operation electric heat is used.
The Smart Fan Auxiliary • This causes the fan to blow room temperature air
Controls may be set to even when the compressor or heater cycles off.
continuous fan. The continuous air movement provides better
overall temperature control in the cool mode.
See Smart Fan – Cooling/Heating on page 5.
The air does not feel The heat pump alone • Use the Electric Heat Option. This turns off the
warm enough during produces air that feels heat pump and warms with electric heat only.
heating operation cooler than desired. NOTE: Use of this option will result in increased energy
consumption.
The unit is not The Smart Fan Auxiliary • See Smart Fan – Cooling/Heating on page 5.
blowing out air Controls may be set to cycle.
The electric heating The power cord is not • Remove the room cabinet and make sure that the
feature does not work firmly attached. yellow connector on the end of the power cord is
firmly engaged.
Temperature display The compressor may • Set the operation control to STOP and then restart
flashes have failed. the unit. If the flashing light reappears within
30 minutes, call for service.
GEAppliances.com
21
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support