19
INSTALLATION INSTRUCTIONS
INSTALLATION
grommet in the left side of the loose box
The wires are then fed inside the firebox and routed
through the available access
the wires are not trapped
in the tapered brackets, Diagram 29
29
AR1968
NOTE: To check gas pressure refer to paragraph 4.11
Diagram 30
30
To replace the burner:
venturi and also the pilot into the aperture in the burner
skin
the slot in the bracket
31
AR1965
To replace the doors and panels, refer to Replacing Parts,
Section 3 and 5
4.9 METHOD 2 - NO FRAME
The front of the chimney breast has to be studded and
boarded to allow the edge kit to be fitted.
the fire is channelled into the cavity between the existing
chimney and the false wall, then vented at the top. The
vent should have a minimum open area of 200mm.
Section 4.1 to 4.8, but do not fit
the frame brackets
You have now removed the box from the appliance and
should use the following:
screws and rawl plugs provided, Diagram 32
32
AR1912
described in Section 3.3, Diagrams 14, 15.
Fit the non-combustible board and the plasterboard as
described in Section 3.3