Filter
Top Products
17
INSTALLATION INSTRUCTIONS
INSTALLATION
AR1198
8
4.7 Place log G at the front of the fire between logs D and E.
DO NOT PLACE THIS LOG ON THE BURNER. IT IS ONLY
TO FILL THE GAP BETWEEN LOGS D AND E. The charred
effect should face the rear of the fire. See diagram 9.
AR1199
9
4.8 With the granules fill the front compartment around the logs
evenly. ENSURE NO GRANULES FALL ON THE BURNER.
See diagram 10.
10
AR1120
NOTE: ENSURE THAT THE LOGS ARE POSITIONED
AS ABOVE. ONLY USE THE CORRECT AMOUNT OF
LOGS AS SPECIFIED IN THE DIAGRAMS.
5. FITTING THE DOOR
5.1 Ensure that the fibreglass seal on the back of the glass frame
is intact then hook the location tabs over the hooks on the
top of the firebox. Replace the nine screws working from
the top down. Tighten the screws evenly. DO NOT OVER
TIGHTEN. See diagram 11.
NEVER OPERATE THE APPLIANCE WHEN THE GLASS
PANEL IS REMOVED OR BROKEN.
5.2 Close the front door of the appliance by pushing centrally
on the RH side, the door catch should locate in the closing
mechanism and finish in the closed position.
5.3 It may be necessary to re-adjust the door closing
mechanism due to vibration whilst in transit. Vertical
adjustment should be made by loosening the two nuts
directly above and below the locking mechanism on the RH
internal side of the outer body. See diagram 11.
AR1295
11
5.4 Horizontal adjustment should be made by loosening the
two bolts, which hold the locking catch to the rear of the
door. See diagram 22.
AR1296
22