Filter
Top Products
4
USER INSTRUCTIONS
1. GENERAL
1.1 Installation and servicing must only be carried out by a
competent person.
1.2 In your own interest, and those of safety, this appliance must
be installed by a competent person in accordance with local
and national codes of practice. Failure to install the appliance
correctly could lead to prosecution.
1.3 In all correspondence, please quote the appliance type and
serial number which can be found on the databadge.
1.4 Ensure that curtains are not positioned above the fire and that
there is a 300mm minimum clearance between the sides of
the fire and any curtains.
1.5 This product is guaranteed for 2 years from the date of
installation, as set out in the terms and conditions of sale
between Gazco and your local Gazco dealer. Please consult
with your local Gazco dealer if you have any questions. In all
correspondence always quote the Model No and Serial No.
2. LIGHTING THE FIRE
2.1 Locate the control valve on the appliance. There are two
control knobs on the valve: the right hand knob controls the
pilot ignition and the left hand knob controls the main burner.
2.2 If your appliance has already been upgraded to battery remote
control, please refer to the instructions provided with the
upgrade to operate the remote control. The following
instructions will work for either situation.
2.3 Ensure that the left-hand control knob is pointing to off ( ).
2.4 Ensure that the right hand control knob is pointing to off (
).
2.5 Press in the right hand control knob and rotate it
anti-clockwise until a click is heard (keep pressing in) and the
knob is pointing to pilot (
). The pilot should now light. If the
pilot has not lit, repeat the procedure until it does.
2.6 Keep the control knob pressed for 10 seconds and then
release it. The pilot should stay alight. If the pilot goes out,
repeat the procedures until it lights.
2.7 If the pilot will not light after repeated attempts, contact the
retailer or installer from whom the appliance was purchased.
2.8 Turn the right hand control to point to main burner (
). The
appliance can now be controlled using the left hand
control knob.
2.9 Turn the left hand control knob to point to low fire (
), the
main burner will light on low. The burner can now be
controlled between low and high settings. Turn the control
knob anticlockwise to increase the flame height and clockwise
to decrease the flame height.
2.10 The flames can be varied from blue to a yellow effect by
moving the aeration lever to the desired position.
See Diagram 1.
THE YELLOW FLAMES WILL APPEAR WHEN THE FIRE HAS
GAINED SUFFICIENT HEAT - TYPICALLY 10 TO 20
MINUTES.
1
AR0944
3. TURNING THE FIRE OFF
3.1 To turn the fire off, locate the control valve, turn the left-hand
control knob until it points to off ( ). The main burner will go
out leaving the pilot burning.
3.2 To turn the pilot off, locate the control valve, turn the right
hand control knob until it points to off (
). The pilot will go
out.
4. LIGHTING THE FIRE WITH A MATCH
If the pilot does not ignite as described in Section 2:
4.1 Press in the right hand control knob and rotate it
anti-clockwise until a click is heard (keep pressing in) and the
knob is pointing to pilot (
), apply a lighted match to the pilot
hood, see Diagram 2.