Filter
Top Products
En-5
PREPARATION
CAUTION!
●
Take care to prevent infants from acci-
dentally swallowing batteries.
●
When not using the Remote Control-
ler for an extended period, remove the
batteries to avoid possible leakage and
damage to the unit.
●
If leaking battery fl uid comes in contact
with your skin, eyes, or mouth, imme-
diately wash with copious amounts of
water, and consult your physician.
●
Dead batteries should be removed imme-
diately and disposed of properly, either
in a battery collection receptacle or to the
appropriate authority.
●
Do not attem pt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use. If the Remote Con-
troller's operating range becomes
appreciably reduced, replace the bat-
teries and press the RESET button with
the tip of a ballpoint pen or other small
object.
Load Batteries (AAA/R03/LR03
×
2)
1
Press and slide the battery compartment lid on the
reverse side to open it.
Slide in the direction of the arrow while pressing the mark.
2
Insert batteries.
Be sure to align the battery polarities ( ) correctly.
3
Close the battery compartment lid.
Set the Current time
1
Press the CLOCK ADJUST button (Fig. 5
P
).
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET ( / ) buttons (Fig. 5
O
) to
adjust the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed
in five-minute increments; hold the buttons depressed to change the
time quickly in ten-minute increments.)
3
Press the CLOCK ADJUST button (Fig. 5
P
) again.
This completes the time setting and starts the clock.
To Use the Remote Controller
●
The Remote Controller must be pointed at signal receiver (Fig. 3
4
) to operate
correctly.
●
Operating Range: About 23ft (7 m).
●
When a signal is properly received by the indoor unit, a beeping sound will be
heard.
●
If no beep is heard, press the Remote Controller button again.
Remote Controller Holder
3 To remove the Remote Con-
troller (when use at hand).
1 Mount the Holder. 2 Set the Remote Controller.
Screws
Insert
Press in
Slide up
Pull out
Turn on the Power
1
Turn on the circuit breaker