Filter
Top Products
En-12
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Controller is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2
2
) more than
3 seconds and less than 10 seconds on the main unit control
panel.
To stop operation, press the MANUAL AUTO button (Fig. 2
2
) for 3 seconds.
●
When the air conditioner is oper-
ated by the controls on the MANUAL
AUTO button, it will operate under
the same mode as the AUTO mode
selected on the Remote Controller
(see page 7).
●
The fan speed selected will be
“AUTO” and the thermostat setting
will be standard (76
°F
).
MINIMUM HEAT OPERATION
•
The room temperature can be maintained at 50 °F by pressing the MIN. HEAT
button (Fig.5
F
) so as to prevent the room temperature from falling too far.
To use MINIMUM HEAT OPERATION
Press the MIN. HEAT button (Fig.5
F
)
The OPERATION indicator lamp (green) (Fig. 3
5
) will go out, and the ECONOMY
indicator lamp (green) (Fig. 3
7
) will light.
To stop MINIMUM HEAT OPERATION
Press the START/STOP button (Fig.5
K
)
Then the operation stops.
About the MINIMUM HEAT Operation
•
The Heating mode will not operate if the room temperature is high enough.
While MINIMUM HEAT OPERATION
is in progress, only the following
operation can be used.
•
SWING
• SLEEP
OPERATION
● Indicator Lamp
: Lighting : OFF
TIMER
ECONOMY