Filter
Top Products
En-13
CLEANING AND CARE
●
Before cleaning the indoor unit, be sure to turn it off and disconnect the Power Supply Cord.
●
Be sure the Intake Grille (Fig. 1
8
) is installed securely.
●
When removing or replacing the air fi lters, be sure not to touch the heat exchanger, as person-
al injury may result.
CAUTION!
Cleaning the Intake Grille
1. Remove the Intake Grille.
1 Place your fingers at both lower ends of the grille
panel, and lift forward; if the grille seems to catch
partway through its movement, continue lifting up-
ward to remove.
2 Pull past the intermediate catch and open the Intake
Grille wide so that it become horizontal.
2. Clean with water.
Remove dust with a vacuum cleaner; wipe the indoor
unit with warm water, then dry with a clean, soft cloth.
3. Replace the Intake Grille.
1 Pull the knobs all the way.
2 Hold the grille horizontal and set the left and right
mounting shafts into the bearings at the top of the
panel.
3 Press the place where the arrow on the diagram in-
dicates and close the Intake Grille.
Cleaning the Air Filter
1. Open the Intake Grille, and remove the
air fi lter.
Lift up the air fi lter’s handle, disconnect the two lower
tabs, and pull out.
2. Remove dust with a vacuum cleaner or
by washing.
After washing, allow to dry thoroughly in a shaded
place.
3. Replace the Air Filter and close the Intake
Grille.
1 Align the sides of the air fi lter with the panel, and
push in fully, making sure the two lower tabs are re-
turned properly to their holes in the panel.
2 Close the Intake Grille.
(For purposes of example, the illustration shows the in-
door unit without Intake Grille installed.)
●
Dust can be cleaned from the air filter either with a
vacuum cleaner, or by washing the fi lter in a solution of
neutral detergent and warm water. If you wash the fi lter,
be sure to allow it to dry thoroughly in a shady place
before reinstalling.
●
If dust is allowed to accumulate on the air fi lter, airfl ow will be
reduced, lowering operating effi ciency and increasing noise.
●
During periods of normal use, the Air Filters should be
cleaned every two weeks.
●
Don't operate the air conditioner with being opened the
intake grille.
●
When used for extended periods, the indoor unit may accumulate dust inside, reducing its performance. We recom-
mend that the indoor unit be inspected regularly, in addition to your own cleaning and care. For more information,
consult authorized service personnel.
●
When cleaning the indoor unit’s body, do not use water hotter than 104 °F, harsh abrasive cleansers, or volatile agents
like benzene or thinner.
●
Do not expose the indoor unit’s body to liquid insecticides or hairsprays.
●
When shutting down the indoor unit for one month or more, fi rst allow the fan mode to operate continuously for half a
day to allow internal parts to dry thoroughly.
Intake Grille
Air fi lter handle
Air fi lter (Right & Left)
Mounting
shaft
Bearing
Knob
Mounting
shaft
Knob
1
2
3
1
2
3
Hooks(two places)
Hooks(two places)