Filter
Top Products
DO THIS:
PRESS
MODE BUTTON
SELECT HEAT
YOU WILL SEE:
HEATING FEATURE (on some models):
DO THIS:
PRESS TO RESET
YOU WILL SEE:CLEAN FILTER FEATURE:
Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation and cooling. The
LED (light) will illuminate after 250 hours of operation. To reset after cleaning the filter, press the “Clean Filter” button and the
light will go off.
Note: This feature can be used with any combination of FAN Speeds, Timer, or Sleep Modes. When in the “Heat” Mode,
the fan will run continuously while heat is needed. The temperature will automatically be maintained anywhere between
55°F (13°C) and 80°F (27°C). When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample
the room air.
8
Air Conditioner Features
(continued)
DO THIS:
PRESS SLEEP
PAD
YOU WILL SEE:SLEEP FEATURE:
The Sleep Mode can be selected with a Heating or Cooling Mode. Note: In this “MODE” the selected cooling temperature will
increase by 2 degrees F, 30 minutes after the mode is selected. The temperature will then increase by another 2 degrees F, after
an additional 30 minutes. This new temperature will be maintained for 7 hours before it returns to the originally selected
temperature. If this Mode is selected with Heat, the set temperature will Decrease at the same time pattern. This ends the
“Sleep” MODE and the unit will continue to operate as originally programmed. The “Sleep” MODE program can be cancelled
at any time during operation by pressing “Sleep” MODE button.