Filter
Top Products
Check
Filter
Sleep
FanFaster
FanSlower
Temp/Timer
Temp/Timer
Auto
Temp
Clean
Air
FanOnly
Cool
EnergySaver
Mode
On
Off
/
Remote
Sensing
Timer
Check
Filter
Sleep
FanFaster
FanSlower
Temp/Timer
Temp/Timer
Auto
Temp
Clean
Air
FanOnly
Cool
EnergySaver
Mode
On
Off
/
Remote
Sensing
Timer
Check
Filter
Sleep
FanFaster
FanSlower
Temp/Timer
Temp/Timer
Auto
Temp
Clean
Air
FanOnly
Cool
EnergySaver
Mode
On
Off
/
Remote
Sensing
Timer
Check
Filter
Sleep
FanFaster
FanSlower
Temp/Timer
Temp/Timer
Auto
Temp
Clean
Air
FanOnly
Cool
EnergySaver
Mode
On
Off
/
Remote
Sensing
Timer
7
Air Conditioner Features
(continued)
TO USE THE
ENERGY SAVER FEATURE:
DO THIS:
PRESS MODE
BUTTON
CHOOSE
ENERGY SAVER
Note: In this mode, the fan will continue to run for another 3 minutes after the compressor shuts off. The fan
then cycles on for 2 minutes at 10 minute intervals until the room temperature is above the set temperature, at
which time the unit cooling system turns back on.
YOU WILL SEE:
TIMER-DELAY START/STOP
FEATURE:
YOU WILL SEE HOW MUCH
TIMEISCHOSEN:
FIRST
DO THIS:
PRESS
TIMER
BUTTON
Note 1: For Delay Stop, the unit must be in the ON position.
Note 2: For Delay Start, the unit must be in the OFF position.
First,PRESS TIME BUTTON
Then,To adjust timer setting, tap or hold the UP arrow(^) or DOWN arrow (v) to change the delay time by .5 hour increments
up to 10 hours, then by 1 hour increments up to 24 hours. The control will count down the time remaining until start (8, 7.5,
7, etc.). The Delay Start mode automatically selects cooling with maximum Fan Speed. The temperature maintained will be
the same as previously set. To change the set temperature, press “COOL” then Up or Down arrows until the desired
temperature is indicated on the display. After 5 seconds, the control will automatically change the display back to the hours
remaining until the unit will start/stop. PRESSING the “ON” /“OFF” at any time will cancel the delay function.The delay
Start/Stop feature will work until the either starts or stops. Once this has happened then the above setps have to be
repeated again.
THEN
DO THIS:
PRESS
TEMP/TIMER
SET BUTTON
LIGHT ON
LIGHT
ON