Friedrich YS10M10 Air Conditioner User Manual


 
28
OPTIONAL: The factory assembles the supply cord so that it exits the left
side of the unit at the bottom. At the consumer’s discretion,
.tinu eht fo edis thgir eht tixe ot detuor eb nac droc ylppus eht
To do this, route the supply cord to the right side. Pull the
supply cord taunt through the loops (Refer to Cord Routing
Change, Figure 30) and route the cord down.
STEP 13.
STEP 14. Refer to the Control Panel Operation section for instructions.
STEP 15. You are now ready to control the comfort level of the room.
Use Tool Provided
Please use the provided tool to attach the decorative front to the chassis.
Figure 28
FRR024
NOTE: WHEN INSTALLING THE CHASSIS
SEAL GASKET; BEGIN AT EITHER BOTTOM
CORNER AND GO UP THE SIDE & ACROSS
THE TOP & DOWN THE OPPOSITE SIDE.
POWER CORD
CLIP
CHASSIS SEAL
GASKET (ITEM 14)
Figure 29
B
USE HAND TOOLS
DO NOT OVER TIGHTEN
LOCATION OF GRILLE
REMOVAL TOOL
FRR053
To attach and prevent damage to the front grille align the
cord notch over the cord and center the fresh air lever, then
align and tighten the four (4) captive screws as indicated by
the arrows in Figure 28. Before closing the front panel, be
sure the filter is in place. Make sure curtains do not block
the side air intakes.