Filter
Top Products
5
Care and maintenance
To remove filter
Simply turn the unit off and pull the filter frame up and towards you (See
Figure 6). Clean with warm water and a mild detergent, rinse, dry, and
replace by sliding the filter back into position behind the front panel.
Figure 6
READ THIS FIRST! Electrical Requirements
IMPORTANT: Beforeyoubegintheactualinstallationoftheairconditioner,
be sure your electrical requirements are as described below. Consult an
electrical professional as necessary to insure home wiring is per local
electrical codes.
CIRCUIT PROTECTION - An overloaded circuit will invariably cause mal-
function or failure of an air conditioner, therefore, it is necessary that the
electrical protection is adequate. All portable chassis models require a 15
amp fuse or circuit breaker for over-amperage protection. Due to momen-
tary high currentdemand when your airconditioner isstarted, use a "TIME
DELAY" fuse or aHACR type circuit breaker. Consult your dealer or power
companyif in doubt.
YourairconditionermustbeconnectedtoapowersupplywiththesameA.C.
voltageandhertzas markedontheunitnameplate.Onlyalternatingcurrent
(A.C.), no direct current (D.C.),can be used.
The power cord has a plug with a grounding prong of approved type and a
matching plug receptacle with ground is required. Refer to page 3 for the
correct type of plug receptacle for yourmodel.
WARNING: NEVER CUT OR REMOVE THE GROUNDING PRONG
FROMPLUG. NEVERUSE EXTENSION CORDS TOOPERATE ANAIR
CONDITIONER.
Items required for installation (provided in straight cooling units only)
ITEM NO. DESCRIPTION QTY.
1
2
3
4
SCREW, SHEET METAL, #8 x
"
SCREW, PHILLIPS, TRUSS HEAD, #8 x ½"
SCREW, HEX, #8 x
"
SCREW, PHILLIPS, #8 x 1 ¼"
8
4
10
2
5
6
GRAY GASKET, FOAM, 1" x 1 ½" x 42"
WHITE GASKET, FOAM, 1" x 1 ½" x 48"
1
1
Installation instructions
NOTE:
This section includes installation instructions for window mount and thru-the-wall mount methods. X-Star
®
heat/cool units are designed for permanent
thru-the-wall installation. Mounting the unit in a window will require a window mounting accessory kit, available through your Friedrich dealer.
ITEM NO. DESCRIPTION QTY.
7
8
LEFT SIDE CURTAINASSEMBLY
RIGHT SIDE CURTAINASSEMBLY
1
1
9
10
11
DECORATIVE FRONT PANEL
CABINET OR SLEEVE
AIR CONDITIONING UNIT
1
1
1
ITEM1 ITEM2 ITEM3 ITEM4 ITEM5 ITEM6
ITEM7 ITEM8 ITEM9 ITEM10 ITEM11
Electrical Shock Hazard
Make sure your electrical receptacle has the
same configuration as your air conditioner’s
plug. If different, consult a Licensed Electrician.
Do not use plug adapters.
Do not use an extension cord.
Do not remove ground prong.
Always plug into a grounded 3 prong outlet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
WARNING