Filter
Top Products
2
Make sure the wiring is adequate for your unit.
If youhave fuses, they should beof the time delaytype. Before youinstall
or relocatethis unit,besurethattheamperageratingofthecircuitbreaker
or time delay fuse does not exceed the amp rating listed in Figure 1.
DO NOT use an extension cord.
The cord provided will carry the proper amount of electrical power to the
unit; an ex ten sion cord will not.
Make sure that the receptacle is compatible with
the air conditioner cord plug provided.
This insures proper grounding. If you have a two prong receptacle you
will need to have it replaced with a grounded receptacle by a certi
ed
electrician. The grounded receptacle should meet all national and local
codes and ordinances. Under no circumstances should you remove the
ground prong from the plug. You must use the three prong plug furnished
with the air conditioner.
Test the power cord
AllFriedrichroomairconditionersareshippedfromthefactorywithaLeakage
CurrentDetectionInterrupter(LCDI)equippedpowercord.TheLCDIdevice
meets the UL and NEC requirements for cord connected air conditioners
effective August 2004.
Totest your power supply cord:
1. Plugpower supply cord into agrounded 3 prong outlet.
2. Press RESET (See Figure 2).
3. Press TEST (listen forclick; Reset button tripsand pops out).
4. Press and release RESET (listen for click; Reset button latches and
remains in). Thepower supply cord is readyfor operation.
NOTE:LCDI device isnot intended to beused asa switch.
Once plugged in, the unit will operate normally without the need to reset
the LCDI device.
.
WARNING: Before operating your unit
MODEL
CIRCUITRATING
ORTIMEDELAY
FUSE
REQUIREDWALL
RECEPTACLE
AMP VOLT NEMANO.
XQ0 XQ06
XQ0
XQ10
EQ08
15 125 5-15R
Figure1
Figure2
TEST
RESET
WARNING
TEST BEFORE EACH USE
1. PRESS RESET BUTTON
2. PLUG LDCI INTO POWER
RECEPTACLE
3. PRESS TEST BUTTON,
RESET BUTTON SHOULD
POP UP
4. PRESS TEST BUTTON,
FOR USE
DO NOT USE IF ABOVE TEST
FAILS
WHEN GREEN LIGHT IS ON
IT IS WORKING PROPERLY
RESET
TEST
NOTE:YourLCDIdevicewill resemble oneof theseillustrations.
Ifthedevicefailstotripwhentestedorifthepowersupplycordisdamaged,it
mustbe replacedwith anewsupplycordfrom the manufacturer.Werecom-
mendyoucontactourTechnicalAssistanceLineat(800)541-6645.
Toexpedite service, please have your modeland serial number available.
Electrical Shock Hazard
Make sure your electrical receptacle has the
same configuration as your air conditioner’s
plug. If different, consult a Licensed Electrician.
Do not use plug adapters.
Do not use an extension cord.
Do not remove ground prong.
Always plug into a grounded 3 prong outlet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
WARNING