Filter
Top Products
FIGURE A
AIR DISCHARGE PLENUM
FIGURE B
SIDE PROFILE
OF WALL SLEEVE
RAISED LEDGE
GASKET
FRONT UNIT REST
Remove the black rubber gasket from the air discharge plenum of the air conditioner (see fi g. A). Look inside the wall sleeve and
check to see if a black rubber gasket is already in place along the bottom front (see fi g. B). If one is not in place, thoroughly clean
the sleeve area between the front unit rests and the raised ledge (see fi g. B). Once this area is clean and completely dry, peel the
orange backing from the gasket and apply it to the base of the sleeve (see fi g. B). Once the gasket has been properly applied, the
sleeve is ready for the air conditioner to be installed per the installation instructons.
SEALING GASKET INSTALLATION INSTRUCTIONS
MECHANICAL HAZARD
WARNING
Sharp edges and corners. Be careful with
the sharp edges and corner. Wear protective
clothing and gloves, etc.
Failure to do so could result in serious injury.
WallMaster
®
Thru-the-Wall
MECHANICAL HAZARD
WARNING
Be careful with the sharp edges and corners.
Wear protective clothing and gloves, etc.
Failure to do so could result in serious injury.
CUT/SEVER HAZARD
49
SEALING GASKET INSTALLATION INSTRUCTIONS