Filter
Top Products
Discharge Air Plenum
Slot
Tab
Latches
Return air grille
Latch
Slot
Tab
Return Air Grille
ROUTINE MAINTENANCE (Continued)
Do not drill holes in the bottom of the drain pan or the
underside of the unit. Not following this notice could
result in damage to the unit or condensate water leaking
inappropriately which could cause water damage to
surrounding property.
NOTICE
SLEEVE / DRAIN
Inspect the sleeve and drain system periodically (at least yearly or bi-yearly) and clean of all obstructions and
debris. Clean both areas with an antibacterial and antifungal cleaner. Rinse both items thoroughly with water and
ensure that the drain outlets are operating correctly. Check the sealant around the sleeve and reseal areas as
needed.
FRONT COVER
Clean the front cover when needed. Use a mild detergent. Wash and rinse with warm water. Allow it to dry
thoroughly before reinstalling it in the chassis.
CLEARANCES
Inspect the surrounding area (inside and outside) to ensure that the unit’s clearances have not been compromised or
altered.
22
Condenser
Air Discharge
Compressor
Fan Blade
Capillary Tubes
Bypass Valve
Electrical
Compartment
On/Off Switch
Thermostat
Air Intake
Air Discharge
Front Cover
Air Discharge
Vents
Sleeve
Indoor Blower
Wheel
Air Intake
Fan/Blower
Motor
Condenser
Condenser
Shroud Brace
Condenser Coil
Condenser/Fan Blade
Shroud