Filter
Top Products
www.fmiproducts.com
121082-01K
5
Remote
Control
PRODUCT IDENTIFICATION
Figure 1 - Log Base Assembly
Log Set
Base
Assembly
Front
Burner
Rear
Burner
Top Louver
Assembly
Fireplace
Hood
Bottom Louver Assembly
Screen
Assembly
Top Outer Casing
Figure 2 - Fireplace
UNPACKING
CAUTION: Do not remove
data plates attached to heater
base assembly. The data plates
contain important warranty and
safety information.
1. With utility knife, cut carton all the way
around above staples on bottom tray. Lift
carton off of heater. Remove packing.
Note: Hood is located on top of replace
in a carton.
2.
Locate one screw above top left corner
of replace screen. Remove and discard
screw. Lift replace screen up and pull out
to remove.
3. Remove protective packaging applied to
logs, log base assembly and replace.
4. Check heater for any shipping damage. If
heater is damaged call FMI PRODUCTS,
LLC at 1-866-328-4537 for replacement
parts before returning to dealer.
PRODUCT FEATURES
OPERATION
This vent-free replace is clean burning. It re-
quires no outside venting. There is no heat loss
out a vent or up a chimney. Heat is generated
by both realistic ames and glowing embers.
When used without blower, replace requires
no electricity making it ideal for emergency
backup heat.
SAFETY DEVICE
This replace has a pilot with an Oxygen
Depletion Sensing (ODS) safety shutoff sys-
tem. ODS/pilot is a required feature for vent-
free room heaters. ODS/pilot system shuts off
replace if there is not enough fresh air.
IGNITION SYSTEM
This replace has an electronic ignitor to light
heater fuel supply.
REMOTE CONTROL
This replace is equipped with a thermostat
remote control. Remote can also be used
manually. Use this remote to control tempera-
ture and ame height.